Assembly
Parts
- 2 100mm ground steel rod
- 2 M3 nut
- 2 M3x10mm screw
- 2 Oilite bushing
- Some glue
- 2 magnet
Tools
3D printed parts
- 1 hinge component
- 1 main body
- 1 rod handle
- 1 slider
Method
Step 1: Attach hinge component
Attach the hinge component to the main body with using two M3x10mm screws and M3 nuts with a M2.5 hex head screwdriver.
Step 2: Attach rods
Push the 100mm ground steel rods into the hinge component. If they are not tight, use some glue.
Step 3: Attach magnets
Use glue to attach two magnets in the cavities on the outer sides of the rod supports.
Step 4: Insert slider's linear bushings
Push the Oilite bushings through the holes in the slider.
Step 5: Insert slider
Slide the slider onto the [rod]s, making sure that the linear bushings are correctly in place.
Step 6: Attach rod holder
Push the rod handle onto the rods. If it is not tight, use some glue.