Assemble Slider

Method

Step 1: Assembling the slider

Attach the bridge (?) onto the slider using two M3x8mm screws with a M2.5 hex screwdriver.

Step 2: Glue the magnet onto the slider

Use some glue to attach the 2.5x7x2.5mm N42 Neodymium magnet into the cavity of the bridge.

Step 3: Attach the limit switch screw

Screw in an M3x8mm screw at the back of the slider with a [M2.5 hex screwdrover] such that it is poking out slightly (by about 3mm). This will be used to push the limit switch during calibration of the instrument.

You have now successfully built the assembled slider. You will need this later.


Previous page | Next page